-
اشکال در کانفیگ AS5300
با سلام..
من روی اکسس سرور 5300 این منشکل رو دارم که وقتی خط E1 رو به روتر وصل می کنم چراغ پورت همچنان نارنجی (در حالت shutdown) باقی می مونه در حالیکه در کانفیگ روتر shutdown نیستند... روی هر 4 پورت تست کردم و فرقی نکرد...
در ضمن در show controller e1 3 هم down نشون میده.. اشکال در کجاست؟
من خط E1 روی پورت چهارم ست کردم و کانفیگ رو هم اینجا میزارم. اساتید هرکجا در کانفیگ ایرادی مشاهده کردند لطفا بیان کنند..
با تشکر
Using 3215 out of 124920 bytes
!
version 12.3
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
hostname Router
!
boot-start-marker
boot-end-marker
!
enable secret 5 xxxxxxxxxxxx
!
username xxxxxxxxxx privilege 15 password 7 xxxxxxxxxxx
spe 2/0 2/9
firmware location system:/ucode/mica_port_firmware
!
!
resource-pool disable
!
aaa new-model
!
!
aaa authentication login default group tacacs+ local
aaa authentication login local local
aaa authentication enable default group tacacs+ enable
aaa authentication ppp default if-needed group tacacs+ local
aaa authorization network default group radius local
aaa accounting nested
aaa accounting update newinfo
aaa accounting network default start-stop group tacacs+
aaa session-id common
ip subnet-zero
ip name-server 217.218.155.104
ip name-server 217.218.155.105
ip name-server 217.218.127.105
ip name-server 217.218.127.104
ip name-server 192.9.9.3
ip name-server 4.2.2.4
!
!
isdn switch-type primary-net5
!
!
!
!
!
!
!
!
!
!
!
!
controller E1 0
shutdown
pri-group timeslots 1-31
!
controller E1 1
shutdown
clock source line secondary 1
!
controller E1 2
shutdown
!
controller E1 3
framing NO-CRC4
clock source line primary
pri-group timeslots 1-31
!
!
interface Ethernet0
no ip address
no ip route-cache
shutdown
!
interface Serial0:15
no ip address
isdn switch-type primary-net5
no cdp enable
!
interface Serial3:15
ip unnumbered FastEthernet0
encapsulation ppp
isdn switch-type primary-net5
isdn incoming-voice modem
isdn calling-number xxxxxxx
no keepalive
ppp authentication pap
!
interface FastEthernet0
ip address xxxxxxxxxxxxx xxxxxxxxxxxx
no ip route-cache
no ip mroute-cache
duplex auto
speed auto
no cdp enable
!
interface Group-Async0
physical-layer async
ip unnumbered FastEthernet0
ip nat inside
encapsulation ppp
ip tcp header-compression
no ip mroute-cache
async mode dedicated
peer default ip address pool ASYNC
compress mppc
no fair-queue
ppp authentication pap chap ms-chap
no group-range
!
ip local pool ASYNC xxxxxxxxxxxxx xxxxxxxxxxxxxx
ip nat inside source list 8 pool oveld overload
ip classless
ip route 0.0.0.0 0.0.0.0 xxxxxxxxxxxxxxx
no ip http server
!
!
!
ip access-list extended no-telnet
deny icmp any any
deny tcp any any eq 135
deny tcp any any eq 139
deny tcp any any eq 445
permit udp any any
deny tcp any any eq telnet
deny udp any any eq tftp
deny udp any any eq 135
deny udp any any eq netbios-ns
deny udp any any eq netbios-dgm
deny udp any any eq netbios-ss
deny tcp any any eq 593
deny tcp any any eq 707
deny udp any any eq 707
deny udp any any eq 1433
deny udp any any eq 1434
deny tcp any any eq 4444
deny tcp any any eq 17300
permit ip any any
no logging trap
!
tacacs-server host xxxxxxxxxxxxxxx
tacacs-server timeout 20
tacacs-server directed-request
tacacs-server key 7 xxxxxxxxxxx
!
!
!
!
!
line con 0
line 1 60
session-timeout 10
exec-timeout 0 0
no flush-at-activation
modem Dialin
modem autoconfigure type mica
autocommand ppp
transport input all
autoselect during-login
autoselect ppp
line aux 0
line vty 0 4
password 7 xxxxxxxxxx
!
end
-
[LEFT]controller E1 1
clock source line secondary 1
pri-group timeslots 1-31[/LEFT]
[LEFT]No problem config [/LEFT]
-
سلام
چند تا موضوع رو چک کن.
اول Framing میتونه CRC4 باشه .
اگه E1 رو از مودم گرفتی کابلهاش رو احتمال داره اشتباه وصل کرده باشی. جای کابلهای Coax رو عوض کن
اصلا برای اینکه ببینی E1 UP است یا نه از کابل Loop استفاده کن.
از دستور Sho isdn status برای اینکه ببینی کدوم لایه اشکال داره استفاده کن. و همچنین از debug isdn q921 و debug isdn q931
موفق باشی
-
حمید جان... میشه بگی فرقه CRC4 با NO-CRC4 چیه ؟ از کجا باید بفهمی کدومه؟
در ضمن من چراغ مودمم سبزه یعنی نرماله بازم ممکنه جای کابلها عوض شده باشه؟
-
من show isdn status رو زدم این مشخصات رو به من داد..
من سر در نیاوردم.. میشه یه راهنمایی بکنین
[LEFT]Global ISDN Switchtype = primary-net5
ISDN Serial0:15 interface
dsl 0, interface ISDN Switchtype = primary-net5
Layer 1 Status:
DEACTIVATED
Layer 2 Status:
TEI = 0, Ces = 1, SAPI = 0, State = TEI_ASSIGNED
Layer 3 Status:
0 Active Layer 3 Call(s)
Active dsl 0 CCBs = 0
The Free Channel Mask: 0x00000000
Number of L2 Discards = 0, L2 Session ID = 2
Total Allocated ISDN CCBs = 0[/LEFT]
[RIGHT]البته من به یک مشکل دیگه هم برخوردم.. در بعضبی مواقع چراغ RA روی پورت E1 روشن میشه.. این معنیش چیه.. در حالت معمولی وقتی پورت shutdown است یا سیمی بهش وصل نیست چراغ LA روشن میشه ولی الان چراغ RA روشن میشه .. دوستان لطفا راهنمایی کنید[/RIGHT]
-
[QUOTE=astalla;215764]حمید جان... میشه بگی فرقه CRC4 با NO-CRC4 چیه ؟ از کجا باید بفهمی کدومه؟
در ضمن من چراغ مودمم سبزه یعنی نرماله بازم ممکنه جای کابلها عوض شده باشه؟[/QUOTE]
آره ممکنه !
-
کسی فرقه چراغهای RA و LA رو نمیدونه؟
اصلا این دو تا چراغ چه مواقعی روشن میشن؟
-
FbpCore(config)#controller e1 0
FbpCore(config-controller)#no shutdown
FbpCore(config-controller)#clock source line primary
FbpCore(config-controller)#framing no-crc4
FbpCore(config-controller)#pri-group timeslots 1-31
-----
FbpCore#sh controllers e1 0
E1 0 is up.
Applique type is Channelized E1 - unbalanced
No alarms detected.
Version info of Slot 0: HW: 1, Firmware: 4, PLD Rev: 11
Framer Version: 0x8
----
FbpCore# sh isdn status
Global ISDN Switchtype = primary-net5
ISDN Serial0:15 interface
dsl 0, interface ISDN Switchtype = primary-net5
Layer 1 Status:
ACTIVE
Layer 2 Status:
TEI = 0, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
Layer 3 Status:
5 Active Layer 3 Call(s)
Activated dsl 0 CCBs = 5
The Free Channel Mask: 0x8FFF5FFE
ISDN Serial1:15 interface
dsl 1, interface ISDN Switchtype = primary-net5
Layer 1 Status:
DEACTIVATED
Layer 2 Status:
Layer 2 NOT Activated
Layer 3 Status:
0 Active Layer 3 Call(s)
Activated dsl 1 CCBs = 0
The Free Channel Mask: 0x7FFF7FFF
Total Allocated ISDN CCBs = 5