من هم یکی از این نوع روترها رو دارم نتونستم روش nat رو فعال کنم
ip nat inside source list 1 interface ethernet 0
میگه همچین دستوری وجود ندارد
کد:
myrouter(config)#ip nat pool
^
% Invalid input detected at '^' marker.
myrouter(config)#
کد:
myrouter#show ver
Cisco Internetwork Operating System Software
IOS (tm) 2500 Software (C2500-I-L), Version 11.2(18), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Mon 05-Apr-99 19:52 by jaturner
Image text-base: 0x0302315C, data-base: 0x00001000
ROM: System Bootstrap, Version 11.0(10c), SOFTWARE
BOOTFLASH: 3000 Bootstrap Software (IGS-BOOT-R), Version 11.0(10c), RELEASE SOFT
WARE (fc1)
myrouter uptime is 1 hour, 33 minutes
System restarted by power-on
System image file is "flash:c2500-i-l.112-15", booted via flash
cisco 2511 (68030) processor (revision M) with 2048K/2048K bytes of memory.
Processor board ID 15277565, with hardware revision 00000000
Bridging software.
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
1 Ethernet/IEEE 802.3 interface(s)
2 Serial network interface(s)
16 terminal line(s)
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read ONLY)
Configuration register is 0x2102
myrouter#