ببخشید چند تا سوال:
در قسمت BootFile حتما باید همین boot\pxeboot.com رو بگذاریم؟
درقسمت Curent Direction هم مسیر ایمیج رو قرار بدیم؟
وقتی که این تنظیمات رو ok کردیم سمت کلاینت (لپ تاپ) فقط کافیه که از رو شبکه بوت بشه و سرور بهش آی پی میده و درخواست میده برای Image ؟ کار خاصی نباید رو کلاینت (لپ تاپ) انجام داد آخه بعضی سایت ها دیدم که این طوری راهنمایی کردن:
Installing Windows 7 can be done by many methods, one of these important one is "Over a Network".
Although you can use this method to do this you can also use the PE-Boot Disk to install Windows 7 over a network.
Here are the steps that you should use:
1. Copy the contents of the Windows 7 installation disc to a server location and set it up as a network share.
2. Download the following program to the server: TFTPboot.exe
Quote
(http://www.megaupload.com/?d=V04T7KQ8)
3. Exact the files from the download to the C: drive.
4. From the extracted files, run TFTP32.exe.
5. Click settings and change the following: Uncheck Option negotiation, Check PXE Compatibility, Check Allow ‘\’ As virtual root. Make sure Base Directory is a single dot. Click Ok.
6. Select the DHCP tab and setup the IP pool starting address and Size of pool for your network. For Boot File, use: boot\pxeboot.com
7. On the computer that you want to install Windows 7 on, enter the Boot Selection Menu (usually by hitting F12 when starting up the machine).
8. Select Network Boot (or PXE Boot). If this option is not available, check the BIOS settings to make sure the feature is available and turned on.
9. Follow any prompts and then wait. After a while, the computer should boot to a CMD window.
10. In the CMD window, type: net use z: \\{server IP}\{share name}
11. Log in with a network username and password (Use the ‘domain\username’ format for username).
12. Type Setup and the Windows 7 installation should begin.
It all worked surprisingly well in the end. The TFTPboot setup appears to be complitcated at first glance, but it’s actually just a few settings that need changing. After you have set this up once, in the future you just turn TFTPboot back on and you are ready to install again. No more hunting for discs/
Notes:
- We can use PE-boot disk to reach the Server then use the command Setup.exe to start installation.
- The clients that you will install 7 on them using this method should have Supported NIC with PXE (where PXE is like a driver that helps the NIC to communicate with Boot Strap Protocol using ports 67 & 68 to reach the server, also TFTP port is 69)
- You need to remove memory until you have less than 4GB (on Clients) otherwise it won’t even boot (xms bug)