. Connect the EOC-3220 to your computer with a null modem serial cable.
2. Start a HyperTerminal session: Click Start and then select Programs -> Accessories -> Communications -> HyperTerminal.
3. After the HyperTerminal window appears:
a. Give this new connection a name. Ex: EOC-3220.
b. Select correct COM port. Ex:COM1.
c. Set baud rate as "38400", data bits "8", parity "none", stop bits "1", and flow control as "None". Then press “OK” to bring up the HyperTerminal window.
[FONT='Times New Roman','serif']d. Unplug the power on the POE injector and wait 5 seconds then plug the power back in. [/FONT]
4. Wait until the "#" is displayed in the HyperTerminal window.
5. Type "flash reset", then hit enter.
6. Type "reboot", then hit enter. After the device reboots, all settings will be at factory default.
بعد از لینکه وصل کردی و هایپر ترمینالو روشن کردی یبار باید پاورشو قطع کنی بعد 2 ثانیه وصل کنی. اون موقه بعد از بالا اومدن اینترفیس تو هایپر ترمینال بزن reset flash (با حروف کوچیک) , بعد ریست شدن بزن reboot. وقتی ریست شد میتونی استفاده کنی.
از روی برد چطوری میشه ریست کرد؟
تو تا جای لحیم هست
یکبار هم توضیج دادم باید این دو جا رو 5 ثانیه با یک قطعه فلزی شورتی بدی
من کنار پورت کنسول 4 جای لحیم با شماره های 1 و 2 و 3 و 4 میبینم.
کدامیک را باید اتصال کوتاه کنم؟
داخل پست 1 و 2 همین تاپیک توضیح داده شد
والا یادم نیست یک جایی گفتم چون دو سال گذشته یادم رفته
2 تا کوچیکه رو به هم متصل کنید