مشکل با ماژول HWIC-1ADSL

[maryam73]

من یک ماژول hWIC-1ADSL دارم که روی یک روتر 1841 نصبش کردم و خط ADSL رو به پورتش زدم ولی متاسفانه چراغ CD کارت ADSL ثابت نمی شه کسی از بچه ها در این مورد تجربه ای داره؟ در صورت امکان لطفا منو راهنمایی کنید که بتونم مشکلم رو حل کنم.

ATM0/0/0 is down, line protocol is down
  Hardware is HWIC-DSLSAR (with Alcatel ADSL Module), address is 6412.2530.e4c8 (bia 6412.2530.e4c8)
  MTU 4470 bytes, sub MTU 4470, BW 2048 Kbit/sec, DLY 250 usec,
     reliability 0/255, txload 1/255, rxload 1/255
  Encapsulation ATM, loopback not set
  Keepalive not supported
  Encapsulation(s): AAL5
  23 maximum active VCs, 256 VCs per VP, 0 current VCCs
  VC Auto Creation Disabled.
  VC idle disconnect time: 300 seconds
  Last input never, output never, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: Per VC Queueing
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     0 packets input, 0 bytes, 0 no buffer
     Received 0 broadcasts (0 IP multicasts)
     0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
     0 packets output, 0 bytes, 0 underruns
     0 output errors, 0 collisions, 2 interface resets
     0 unknown protocol drops
     0 output buffer failures, 0 output buffers swapped out

show dsl int atm 0/0/0

ATM0/0/0
Alcatel 20190 chipset information
Line has not yet been activated.
Modem Status: Down (DMTDSL_DO_OPEN)
DSL Mode: Unknown
Interrupts: 318704 (0 spurious)
PHY Access Err: 0
Activations: 0
LED Status: OFF
LED On Time: 0
LED Off Time: 0
Init FW: init_AMR_4.0.018.bin
Operation FW: AMR-E-4.0.018.bin
FW Source: external

DSL: Training log buffer capability is not enabled

با تشکر

---

موضوعات مشابه:

• Cisco 2-Pair G.SHDSL HWIC HWIC-2SHDSL
• 1ADSL+CISCO1721+IP STATIC

---

[maryam73]

کانفیگی که من زدم و جواب نمیده:

interface ATM0/0/0
 no ip address
 no ip route-cache
 no atm ilmi-keepalive
pvc 0/35 
  encapsulation aal5mux ppp dialer
  dialer pool-member 1
!
interface Dialer1
 ip address negotiated
 ip nat outside
 ip virtual-reassembly
 encapsulation ppp
 dialer pool 1
 ppp chap hostname <username>
 ppp chap password 0 *********
 ppp pap sent-username <username> password 0 *********
 !