Video:Small site using BGP on two uplinks into an MPLS VPN network

[LEFT][CODE]http://wiki.nil.com/Video:Small_site_using_BGP_on_two_uplinks_into_an_MPLS_VPN_network[/CODE]The video describes the configuration of a redundant remote site design. The site has a single router that connects the site to the MPLS VPN network with two equal-speed uplinks. Both links are used in a load sharing setup. The router is using BGP as the PE-CE routing protocol.
[B]Contents[/B]



[LIST][*]1 Target audience[*]2 Other prerequisite knowledge[*]3 Reference diagram[*]4 Configuration commands[*]5 Router configurations[/LIST]
[B] Target audience [/B]

CCNA-level engineers who have to configure BGP on customer edge routers connected to MPLS VPN network.
[B] Other prerequisite knowledge [/B]


[LIST][*] [B]Connect a small site to MPLS VPN network using BGP as the PE-CE routing protocol[/B][/LIST]
[B] Reference diagram [/B]

[IMG]http://wiki.nil.com/wk/images/d/db/BGPMPLSVPN_SingleRouterTwoUplinks_Diagram.png[/IMG]
[B] Configuration commands [/B]





[B]router bgp[/B] Select the BGP routing process
[B]neighbor [I]ip-address[/I] remote-as [I]as-number[/I][/B] Configure a BGP neighbor
[B]ip cef[/B] Enable Cisco Express Forwarding (CEF)
[B]maximum-paths [I]number[/I][/B] Enable BGP load balancing
[/LEFT]