والا ما هم تقریبا از همین 1/3/87 دیسکانکتی یوزرها شروع شده ولی بعضی یوزر ها Dc می شن
معمولا بعد از چند بار دیسکانکتی مشکلشون حل می شه . اینو یه نگاه بندازید
پروتکل dowm می شه ولی line -- آپ هست بعد از چند ثانیه یوزر دیسکانکت می شه
روتز ما as 5350 - مودم ایوان siemens STU- مودم دیتا هم tellabs CTU-S
AS 5350#sh interfaces async 1/18
Async1/18 is up, line protocol is up
modem(slot/port)=1/18, state=CONNECTED
dsx1(slot/unit/channel)=3/0/0, status=VDEV_STATUS_ACTIVE_CALL.VDEV_STATUS_ALLO
CATED.VDEV_STATUS_NEGOTIATED.
Hardware is Async Serial
Interface is unnumbered. Using address of FastEthernet0/0 (000.000.000.1)
MTU 1500 bytes, BW 115 Kbit, DLY 100000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, loopback not set
DTR is pulsed for 5 seconds on reset
LCP Open
Open: IPCP, CCP
Last input 00:01:53, output 00:00:01, output hang never
Last clearing of "show interface" counters 6d00h
Input queue: 1/10/0/0 (size/max/drops/flushes); Total output drops: 906
Queueing strategy: weighted fair
Output queue: 0/1000/64/906 (size/max total/threshold/drops)
Conversations 0/16/32 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 86 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
103631 packets input, 7089226 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
130203 packets output, 91369707 bytes, 0 underruns
0 output errors, 0 collisions, 28 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
as 5350#sh interfaces async 1/18
Async1/18 is up, line protocol is down
modem(slot/port)=1/18, state=CONNECTED
dsx1(slot/unit/channel)=3/0/0, status=VDEV_STATUS_ACTIVE_CALL.VDEV_STATUS_ALLO
CATED.VDEV_STATUS_NEGOTIATED.
Hardware is Async Serial
Interface is unnumbered. Using address of FastEthernet0/0 (000.000.000.1)
MTU 1500 bytes, BW 115 Kbit, DLY 100000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, loopback not set
DTR is pulsed for 5 seconds on reset
LCP TERMsent
Closed: LEXCP, IPCP, CCP, CDPCP, BRIDGECP, LLC2, BACP, IPV6CP
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 6d00h
Input queue: 1/10/0/0 (size/max/drops/flushes); Total output drops: 906
Queueing strategy: weighted fair
Output queue: 0/1000/64/906 (size/max total/threshold/drops)
Conversations 0/16/32 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 86 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
103632 packets input, 7089246 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
130204 packets output, 91369715 bytes, 0 underruns
0 output errors, 0 collisions, 28 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
ضمنا اینو هم نگاه کنید
AS 5350#show controllers e1
E1 3/0 is up.
Applique type is Channelized E1 - unbalanced
No alarms detected.
alarm-trigger is not set
Version info of slot 3: HW: 256, PLD Rev: 1
Framer Version: 0x8
Manufacture Cookie Info:
EEPROM Type 0x0001, EEPROM Version 0x01, Board ID 0x0A,
Board Hardware Version 1.0, Item Number 73-5268-01,
Board Revision E0, Serial Number JAE063804M0,
PLD/ISP Version <unset>, Manufacture Date 20-Sep-2002.
Framing is CRC4, Line Code is HDB3, Clock Source is Line.
Data in current interval (52 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
Total Data (last 24 hours)
0 Line Code Violations, 14599 Path Code Violations,
4 Slip Secs, 244 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 262 Unavail Secs
E1 3/1 is down.
Applique type is Channelized E1 - balanced
Far End Block Errors Detected
Receiver has loss of signal.
alarm-trigger is not set
Version info of slot 3: HW: 256, PLD Rev: 1
Framer Version: 0x8
Manufacture Cookie Info:
EEPROM Type 0x0001, EEPROM Version 0x01, Board ID 0x0A,
Board Hardware Version 1.0, Item Number 73-5268-01,
Board Revision E0, Serial Number JAE063804M0,
PLD/ISP Version <unset>, Manufacture Date 20-Sep-2002.
Framing is CRC4, Line Code is HDB3, Clock Source is Line.
Data in current interval (54 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 54 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 54 Unavail Secs
Total Data (last 24 hours)
0 Line Code Violations, 0 Path Code Violations,
0 Slip Secs, 86400 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 86400 Unavail Secs