[quote=y_star;188612]100 بار هم زنگ بزنین مخابرات میگن مشکل ندارن.شماپا فشاری بکنید که مشکل از طرف اونا هست.
خوب بنده خداها دانش این کار رو ندارن .[/quote]
موافقم
Printable View
[quote=y_star;188612]100 بار هم زنگ بزنین مخابرات میگن مشکل ندارن.شماپا فشاری بکنید که مشکل از طرف اونا هست.
خوب بنده خداها دانش این کار رو ندارن .[/quote]
موافقم
من همچنان سر حرف خود هستم که این موارد به شانس آدم برمی گرده !
وقتی همه چیز یکدفعه بطرز عجیبی بهم می ریزه و هیچکس هم پاسخگو نیست و همه می خواهند تو را پاس بدهند سمت باقالی ها در صورتی که خودت باید به هزار نفر جواب بدی تا اعصابت محترمانه برود داخل فرقون و نمودارت رسم شود! خوب اگه نگیم بد شانسیه چی بگیم؟!!
والا ما هم تقریبا از همین 1/3/87 دیسکانکتی یوزرها شروع شده ولی بعضی یوزر ها Dc می شن
معمولا بعد از چند بار دیسکانکتی مشکلشون حل می شه . اینو یه نگاه بندازید
پروتکل dowm می شه ولی line -- آپ هست بعد از چند ثانیه یوزر دیسکانکت می شه
روتز ما as 5350 - مودم ایوان siemens STU- مودم دیتا هم tellabs CTU-S
[LEFT]AS 5350#sh interfaces async 1/18
[COLOR=red][B]Async1/18 is up, line protocol is up[/B][/COLOR]
modem(slot/port)=1/18, state=CONNECTED
dsx1(slot/unit/channel)=3/0/0, status=VDEV_STATUS_ACTIVE_CALL.VDEV_STATUS_ALLO
CATED.VDEV_STATUS_NEGOTIATED.
Hardware is Async Serial
Interface is unnumbered. Using address of FastEthernet0/0 (000.000.000.1)
MTU 1500 bytes, BW 115 Kbit, DLY 100000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, loopback not set
DTR is pulsed for 5 seconds on reset
LCP Open
Open: IPCP, CCP
Last input 00:01:53, output 00:00:01, output hang never
Last clearing of "show interface" counters 6d00h
Input queue: 1/10/0/0 (size/max/drops/flushes); Total output drops: 906
Queueing strategy: weighted fair
Output queue: 0/1000/64/906 (size/max total/threshold/drops)
Conversations 0/16/32 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 86 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
103631 packets input, 7089226 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
130203 packets output, 91369707 bytes, 0 underruns
0 output errors, 0 collisions, 28 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
as 5350#sh interfaces async 1/18
[B][COLOR=red]Async1/18 is up, line protocol is [/COLOR][COLOR=blue]down[/COLOR][/B]
modem(slot/port)=1/18, state=CONNECTED
dsx1(slot/unit/channel)=3/0/0, status=VDEV_STATUS_ACTIVE_CALL.VDEV_STATUS_ALLO
CATED.VDEV_STATUS_NEGOTIATED.
Hardware is Async Serial
Interface is unnumbered. Using address of FastEthernet0/0 (000.000.000.1)
MTU 1500 bytes, BW 115 Kbit, DLY 100000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, loopback not set
DTR is pulsed for 5 seconds on reset
LCP TERMsent
Closed: LEXCP, IPCP, CCP, CDPCP, BRIDGECP, LLC2, BACP, IPV6CP
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 6d00h
Input queue: 1/10/0/0 (size/max/drops/flushes); Total output drops: 906
Queueing strategy: weighted fair
Output queue: 0/1000/64/906 (size/max total/threshold/drops)
Conversations 0/16/32 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 86 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
103632 packets input, 7089246 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
130204 packets output, 91369715 bytes, 0 underruns
0 output errors, 0 collisions, 28 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions[/LEFT]
[RIGHT]ضمنا اینو هم نگاه کنید[/RIGHT]
[LEFT][B][COLOR=blue]AS 5350#show controllers e1[/COLOR][/B]
E1 3/0 is up.
Applique type is Channelized E1 - unbalanced
No alarms detected.
alarm-trigger is not set
Version info of slot 3: HW: 256, PLD Rev: 1
Framer Version: 0x8
Manufacture Cookie Info:
EEPROM Type 0x0001, EEPROM Version 0x01, Board ID 0x0A,
Board Hardware Version 1.0, Item Number 73-5268-01,
Board Revision E0, Serial Number JAE063804M0,
PLD/ISP Version <unset>, Manufacture Date 20-Sep-2002.
Framing is CRC4, Line Code is HDB3, Clock Source is Line.
Data in current interval (52 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
Total Data (last 24 hours)
0 Line Code Violations, 14599 Path Code Violations,
4 Slip Secs, 244 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 262 Unavail Secs
E1 3/1 is down.
Applique type is Channelized E1 - balanced
Far End Block Errors Detected
Receiver has loss of signal.
alarm-trigger is not set
Version info of slot 3: HW: 256, PLD Rev: 1
Framer Version: 0x8
Manufacture Cookie Info:
EEPROM Type 0x0001, EEPROM Version 0x01, Board ID 0x0A,
Board Hardware Version 1.0, Item Number 73-5268-01,
Board Revision E0, Serial Number JAE063804M0,
PLD/ISP Version <unset>, Manufacture Date 20-Sep-2002.
Framing is CRC4, Line Code is HDB3, Clock Source is Line.
Data in current interval (54 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 54 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 54 Unavail Secs
Total Data (last 24 hours)
0 Line Code Violations, 0 Path Code Violations,
0 Slip Secs, 86400 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 86400 Unavail Secs[/LEFT]
این بنده خدا آقای پور هاشمی روز اول از ما پرسید که e1 چطوره. گفتم خوبه
والا نمی دونستم که می خواد این بلا سرش بیاد.
خلاصه میثم خان بمن بگو تریپل چت چیه من تا بحال همچین پروتکلی به گوشم نخورده. 3bit CAS و PRI. هست .
خلاصه هر چی فکر کردم ببنینم همپی مشکلی داشتم یادم اومد که برای اولین بار که E1 ما راه افتاد تا 2 ماه این مشکل رو داشتم.
حتی مودم ها رو هم عوض کردم. آخر می دونی مشکل چی بود.
کابلی که برای اتصال DSL به مودم مخابرات وصل بود روی قفل جک RJ45 او شکسته بود و کاملا سر جاش lock نمی شد و بازی می کرد. به همین خاطر پشت سر هم کاربر های DC می شدن.
تو اون 2 ماه دهن من یکی آسفالت شد. حالا انشالله از شما هم هر چه زودتر حل بشه.
درسته.
تشریف ببرید سالن دستگاه. کابل کواکسیال رو عوض کنید.
یه تجربه داشتم که اینجوری حل شد.
آقای پور هاشمی من هم به اندازه تجربه کمی که دارم می گم کابل مودم به as رو عوض کنین احتمالاَ مشکل خودمو دارین
جناب پورهاشمی مشکل شما شد. اگه حل شده بگید چطوری! چون منم الان چند روزه دقیقا همین مشکل رو دارم. دیگه دارم دیوونه میشم. روز افتتاحیه شبکه ما این مشکل برامون بوجود اوومده. هرچی زحمت کشیدیم و تبلیغات کردیم ، کشک.