No DSP resources available to configure pri-group on controller T1
[RIGHT][RTL]من این مشکل و دارم وقتی میخوام pri تنظیم کنم
[/RTL]
You can potentially encounter the following symptoms or error messages when configuring IP Communications High-Density Digital Voice/Fax Network Module:
% No DSP resources available to configure pri-group on controller T1
%XCCTSP_VOICE-3-NOSDB: No signaling data block is available to build the voice interface(1/0:23) or DSP may not be present
The above errors can be resolved by doing DSP Resource Sharing or adding more digital signal processors (DSPs). For more information refer to the DSP Calculator tool.
Unable to see PRI ports ( controller T1 or E1 ) in the router configuration for an NM-HDV2-2T1/E1 network module. To resolve this issue, you need to enable the card type by issuing the following command: card type {t1 | e1} slot [bay]
و سیسکو گفته باید card type
مشخص کنم در ضورتی که اصلا همچین چیزی رو قبول نمیکنه
[/RIGHT]
