استفاده همزمان E1 -cas and PRI

دوستان سلام بحث واضح است

من روی اکسس سرور 2 لینک cas و 2 لینک تازه وارد دورشوال pri دارم و تو کانفیگ و راه اندازی دچار مشکل هستم اگه ممکنه یه نیگا به اینت بندازین ببینیم چیزی دستگیرم.ن مشد یا نمیشد

[CODE]!
!
isdn switch-type primary-net5
isdn voice-call-failure 0
!
!
!
.
.
!
!
!
!
!
controller E1 0
framing NO-CRC4
line-termination 75-ohm
ds0-group 1 timeslots 1-15,17-31 type r2-digital
cas-custom 1
!
controller E1 1
framing NO-CRC4
clock source line secondary 1
line-termination 75-ohm
ds0-group 1 timeslots 1-15,17-31 type r2-digital
cas-custom 1
!
controller E1 2
framing NO-CRC4
clock source line secondary 2
line-termination 75-ohm
ds0-group 1 timeslots 1-15,17-31 type r2-digital
cas-custom 1
!
controller E1 3
framing NO-CRC4
pri-group timeslots 1-31
!
controller E1 4
framing NO-CRC4
pri-group timeslots 1-31
!
controller E1 5
framing NO-CRC4
clock source line secondary 5
ds0-group 2 timeslots 1-15,17-31 type r2-digital
!
controller E1 6
shutdown
framing NO-CRC4
clock source line secondary 2
ds0-group 1 timeslots 1-15,17-31 type r2-digital
cas-custom 1
!
controller E1 7
shutdown
framing NO-CRC4
clock source line secondary 3
ds0-group 1 timeslots 1-15,17-31 type r2-digital
cas-custom 1
!
.
.
.
!
interface Serial3:15
ip unnumbered FastEthernet0
encapsulation ppp
isdn switch-type primary-net5
isdn incoming-voice modem
peer default ip address pool tst
!
interface Serial4:15
ip unnumbered FastEthernet0
encapsulation ppp
isdn switch-type primary-net5
isdn incoming-voice modem
peer default ip address pool tst
!
.
.
.
!
interface Group-Async1
description connected to Dial-inPCs(modem)
ip unnumbered FastEthernet0
ip access-group 115 in
ip access-group 115 out
encapsulation ppp
no ip route-cache
ip tcp header-compression
no ip mroute-cache
async mode interactive
peer default ip address pool tst
group-range 1 240

.
.
.
.

!
line con 0
line 1 240
no flush-at-activation
modem InOut
modem autoconfigure discovery
autocommand ppp
transport preferred none
transport input all
transport output none
autoselect during-login
autoselect ppp
line aux 0
line vty 0 4



[/CODE]


و اینم خروجی ها
[CODE]
E1 3 is up.
Applique type is Channelized E1 - balanced
No alarms detected.
alarm-trigger is not set
Version info of slot 0: HW: 1, PLD Rev: 11
Framer Version: 0x8
Manufacture Cookie Info:
EEPROM Type 0x0001, EEPROM Version 0x01, Board ID 0x49,
Board Hardware Version 3.1, Item Number 800-3883-02,
Board Revision B0, Serial Number 20413637,
PLD/ISP Version 0.1, Manufacture Date 22-May-2000.
Framing is NO-CRC4, Line Code is HDB3, Clock Source is Internal.
Data in current interval (895 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
Total Data (last 1 15 minute intervals):
0 Line Code Violations, 0 Path Code Violations,
0 Slip Secs, 360 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 360 Unavail Secs
E1 4 is up.
Applique type is Channelized E1 - balanced
No alarms detected.
alarm-trigger is not set
Version info of slot 0: HW: 1, PLD Rev: 11
Framer Version: 0x8
Manufacture Cookie Info:
EEPROM Type 0x0001, EEPROM Version 0x01, Board ID 0x49,
Board Hardware Version 3.1, Item Number 800-3883-02,
Board Revision B0, Serial Number 20413637,
PLD/ISP Version 0.1, Manufacture Date 22-May-2000.
Framing is NO-CRC4, Line Code is HDB3, Clock Source is Internal.
Data in current interval (897 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
Total Data (last 1 15 minute intervals):
0 Line Code Violations, 0 Path Code Violations,
0 Slip Secs, 421 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 421 Unavail Secs


[/CODE]

و


[CODE]
ter#sh isdn status
Global ISDN Switchtype = primary-net5
ISDN Serial3:15 interface
dsl 0, interface ISDN Switchtype = primary-net5
Layer 1 Status:
ACTIVE
Layer 2 Status:
TEI = 0, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
Layer 3 Status:
0 Active Layer 3 Call(s)
Active dsl 0 CCBs = 0
The Free Channel Mask: 0xFFFF7FFF
Number of L2 Discards = 0, L2 Session ID = 1
ISDN Serial4:15 interface
dsl 1, interface ISDN Switchtype = primary-net5
Layer 1 Status:
ACTIVE
Layer 2 Status:
TEI = 0, Ces = 1, SAPI = 0, State = [SIZE=4][COLOR=red]TEI_ASSIGNED[/COLOR][/SIZE]
Layer 3 Status:
0 Active Layer 3 Call(s)
Active dsl 1 CCBs = 0
The Free Channel Mask: 0x7FFF7FFF
Number of L2 Discards = 0, L2 Session ID = 157
Total Allocated ISDN CCBs = 0

[/CODE]

و قسمت غمناک ماجرا


[CODE]
Router# sh controllers e1 call-counters
E1 0:
DS0's Active: 0
DS0's Active High Water Mark: 0
TimeSlot Type TotalCalls TotalDuration
E1 1:
DS0's Active: 0
DS0's Active High Water Mark: 0
TimeSlot Type TotalCalls TotalDuration
E1 2:
DS0's Active: 0
DS0's Active High Water Mark: 0
TimeSlot Type TotalCalls TotalDuration
E1 3:
DS0's Active: 0
DS0's Active High Water Mark: 0
TimeSlot Type TotalCalls TotalDuration
E1 4:
DS0's Active: 0
DS0's Active High Water Mark: 0
TimeSlot Type TotalCalls TotalDuration
E1 5:
DS0's Active: 0
DS0's Active High Water Mark: 0
TimeSlot Type TotalCalls TotalDuration
E1 6:
DS0's Active: 0
DS0's Active High Water Mark: 0
TimeSlot Type TotalCalls TotalDuration
E1 7:
DS0's Active: 0
DS0's Active High Water Mark: 0
TimeSlot Type TotalCalls TotalDuration
Total DS0's Active High Water Mark: 0
Total Calls since System Bootup: 0

[/CODE]

کمک !!

توضیح اینکه خط جدید دورشوال و برای in هستش یکی از ssp قدس و اون یکی از ssp ولیعصر !!