دوستان سلام بحث واضح است

من روی اکسس سرور 2 لینک cas و 2 لینک تازه وارد دورشوال pri دارم و تو کانفیگ و راه اندازی دچار مشکل هستم اگه ممکنه یه نیگا به اینت بندازین ببینیم چیزی دستگیرم.ن مشد یا نمیشد

کد:
!
!
isdn switch-type primary-net5
isdn voice-call-failure 0
!
!
!
. 
. 
!
!
!
!
!
controller E1 0
 framing NO-CRC4
 line-termination 75-ohm
 ds0-group 1 timeslots 1-15,17-31 type r2-digital
 cas-custom 1
!
controller E1 1
 framing NO-CRC4
 clock source line secondary 1
 line-termination 75-ohm
 ds0-group 1 timeslots 1-15,17-31 type r2-digital
 cas-custom 1
!
controller E1 2
 framing NO-CRC4
 clock source line secondary 2
 line-termination 75-ohm
 ds0-group 1 timeslots 1-15,17-31 type r2-digital
 cas-custom 1
!
controller E1 3
 framing NO-CRC4
 pri-group timeslots 1-31
!
controller E1 4
 framing NO-CRC4
 pri-group timeslots 1-31
!
controller E1 5
 framing NO-CRC4
 clock source line secondary 5
 ds0-group 2 timeslots 1-15,17-31 type r2-digital
!
controller E1 6
 shutdown
 framing NO-CRC4
 clock source line secondary 2
 ds0-group 1 timeslots 1-15,17-31 type r2-digital
 cas-custom 1
!
controller E1 7
 shutdown
 framing NO-CRC4
 clock source line secondary 3
 ds0-group 1 timeslots 1-15,17-31 type r2-digital
 cas-custom 1
!
.
.
.
 !
interface Serial3:15
 ip unnumbered FastEthernet0
 encapsulation ppp
 isdn switch-type primary-net5
 isdn incoming-voice modem
 peer default ip address pool tst
!
interface Serial4:15
 ip unnumbered FastEthernet0
 encapsulation ppp
 isdn switch-type primary-net5
 isdn incoming-voice modem
 peer default ip address pool tst
!
.
.
.
!
interface Group-Async1
 description connected to Dial-inPCs(modem)
 ip unnumbered FastEthernet0
 ip access-group 115 in
 ip access-group 115 out
 encapsulation ppp
 no ip route-cache
 ip tcp header-compression
 no ip mroute-cache
 async mode interactive
 peer default ip address pool tst
 group-range 1 240
 
.
.
.
.
 
!
line con 0
line 1 240
 no flush-at-activation
 modem InOut
 modem autoconfigure discovery
 autocommand  ppp
 transport preferred none
 transport input all
 transport output none
 autoselect during-login
 autoselect ppp
line aux 0
line vty 0 4

و اینم خروجی ها
کد:
E1 3 is up.
  Applique type is Channelized E1 - balanced
  No alarms detected.
  alarm-trigger is not set
  Version info of slot 0:  HW: 1, PLD Rev: 11
  Framer Version: 0x8
Manufacture Cookie Info:
 EEPROM Type 0x0001, EEPROM Version 0x01, Board ID 0x49,
 Board Hardware Version 3.1, Item Number 800-3883-02,
 Board Revision B0, Serial Number 20413637,
 PLD/ISP Version 0.1,  Manufacture Date 22-May-2000.
  Framing is NO-CRC4, Line Code is HDB3, Clock Source is Internal.
  Data in current interval (895 seconds elapsed):
     0 Line Code Violations, 0 Path Code Violations
     0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
     0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
  Total Data (last 1 15 minute intervals):
     0 Line Code Violations, 0 Path Code Violations,
     0 Slip Secs, 360 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
     0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 360 Unavail Secs
E1 4 is up.
  Applique type is Channelized E1 - balanced
  No alarms detected.
  alarm-trigger is not set
  Version info of slot 0:  HW: 1, PLD Rev: 11
  Framer Version: 0x8
Manufacture Cookie Info:
 EEPROM Type 0x0001, EEPROM Version 0x01, Board ID 0x49,
 Board Hardware Version 3.1, Item Number 800-3883-02,
 Board Revision B0, Serial Number 20413637,
 PLD/ISP Version 0.1,  Manufacture Date 22-May-2000.
  Framing is NO-CRC4, Line Code is HDB3, Clock Source is Internal.
  Data in current interval (897 seconds elapsed):
     0 Line Code Violations, 0 Path Code Violations
     0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
     0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
  Total Data (last 1 15 minute intervals):
     0 Line Code Violations, 0 Path Code Violations,
     0 Slip Secs, 421 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
     0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 421 Unavail Secs
و


کد:
ter#sh isdn status
Global ISDN Switchtype = primary-net5
ISDN Serial3:15 interface
        dsl 0, interface ISDN Switchtype = primary-net5
    Layer 1 Status:
        ACTIVE
    Layer 2 Status:
        TEI = 0, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
    Layer 3 Status:
        0 Active Layer 3 Call(s)
    Active dsl 0 CCBs = 0
    The Free Channel Mask:  0xFFFF7FFF
    Number of L2 Discards = 0, L2 Session ID = 1
ISDN Serial4:15 interface
        dsl 1, interface ISDN Switchtype = primary-net5
    Layer 1 Status:
        ACTIVE
    Layer 2 Status:
        TEI = 0, Ces = 1, SAPI = 0, State = TEI_ASSIGNED
    Layer 3 Status:
        0 Active Layer 3 Call(s)
    Active dsl 1 CCBs = 0
    The Free Channel Mask:  0x7FFF7FFF
    Number of L2 Discards = 0, L2 Session ID = 157
    Total Allocated ISDN CCBs = 0
و قسمت غمناک ماجرا


کد:
Router# sh controllers e1 call-counters
E1 0:
  DS0's Active: 0
  DS0's Active High Water Mark: 0
  TimeSlot   Type   TotalCalls   TotalDuration
E1 1:
  DS0's Active: 0
  DS0's Active High Water Mark: 0
  TimeSlot   Type   TotalCalls   TotalDuration
E1 2:
  DS0's Active: 0
  DS0's Active High Water Mark: 0
  TimeSlot   Type   TotalCalls   TotalDuration
E1 3:
  DS0's Active: 0
  DS0's Active High Water Mark: 0
  TimeSlot   Type   TotalCalls   TotalDuration
E1 4:
  DS0's Active: 0
  DS0's Active High Water Mark: 0
  TimeSlot   Type   TotalCalls   TotalDuration
E1 5:
  DS0's Active: 0
  DS0's Active High Water Mark: 0
  TimeSlot   Type   TotalCalls   TotalDuration
E1 6:
  DS0's Active: 0
  DS0's Active High Water Mark: 0
  TimeSlot   Type   TotalCalls   TotalDuration
E1 7:
  DS0's Active: 0
  DS0's Active High Water Mark: 0
  TimeSlot   Type   TotalCalls   TotalDuration
Total DS0's Active High Water Mark: 0
Total Calls since System Bootup: 0
کمک !!

توضیح اینکه خط جدید دورشوال و برای in هستش یکی از ssp قدس و اون یکی از ssp ولیعصر !!



موضوعات مشابه: