windows core server 2008

[masoud_anv]

لطفا اگر کسی در این زمینه مطلبی داره بزاره رو سایت

---

موضوعات مشابه:

• کرک برای windows 2008 server core
• Using Windows Server 2008 Core on Windows Virtual PC
• Core Configurator 2.0 for Windows Server 2008 R2 Core Edition

---

[asghari70]

دوست عزيز چه مطلبي رو مي خواي
سرور core يك محيط comman lineهست كه مثل داس ويندوز عمل مي كنه ولي اين قابليت رو داره كه مي تونيد با سرور اصلي خود ارتباط بر قرار كني و دستورات خود را اجرا كنيد
براي استفاده از s core ابتدا بايد عضو دومين بشي براي اين منظور در سرور core دستور زيرا اجرا مي كنيم
netdom join computername / domain :<domaine> /userd:<username> /password :* t

بعد براي تنظيم سروريسها باز هم مي توني با دستورات دلخواه آنها رو انجام بدين
و براي دسترسي به سرويسها و تنظيمات ديگر مي توني در طرف سرور با استفاده از mmc اين كار هارو كني
براي اطلاعات بيشتر مي توني اين رو هم بخوني
Adding a TCP/IP Address - modified from TechNet so it works

1. At a command prompt, type: Ipconfig /all
2. Record the relevant information or redirect it to a text file (ipconfig /all >ipconfig.txt).
3. At a command prompt, type:
Netsh interface ipv4 show interfaces
4. Verify that there is an interface list.
5. At a command prompt, type:
Netsh interface ipv4 set address name="<name of interface from interface list>" static address=<preferred IP address> <mask> <gateway address> 1
6. Verify by typing Ipconfig /all at a command prompt and checking that theres the IP Address you configured
Add a DNS address as per the TechNet list of commands (modified a bit to get it to make sense) - this is obviously important in joining a domain.
1. At a command prompt, type:
Netsh interface ipv4 add dnsserver name=<name of interface from ipconfig /all> address=<IP address of the primary DNS server> index=1
2. At a command prompt, type:
Netsh interface ipv4 add dnsserver name=<name of interface from ipconfig /all> address=<IP address of the secondary DNS server> index=2
3. Repeat as appropriate to add additional servers.
4. Verify by typing Ipconfig /all and checking that all the addresses are correct.

Join a Domain
I like the netdom method of domain joins - easier than the WMI method. And yes thats two d's on the end of password! Netdom join %computername% /domain:<domain> /userd:<domain>\username> /passwordd:*


و اين پاورپوينت
http://download.microsoft.com/downlo...redeepdive.ppt

[silas]

این کتابش هست

http://www.newnets.net/ebooks/core2008.chm